Attention! PE sheet sizing to uniform thickness

As we all know, PE board has a wide range of applications in our life, but PE board application in different places may go through some processes or processing, such as sizing on PE board. Today Xiaobian will give you a specific share of PE plate sizing.

When used, use a brush or scraper to evenly brush the plastic glue on the PE plate to be glued after the process, and the sizing should be uniform in thickness and in place, leaving no bonding blind spots. Apply glue on both sides if necessary. After sizing, it should be aired for 5 ~ 8 minutes, then fit, and pressure to make both sides closely fit! High mechanical strength, stiffness and hardness. Good SLIDING AND WEAR STRENGTH, GOOD ELECTRICAL INSULATION, VERY good CREEP resistance, LOW and stable friction coefficient EXCELLENT WEAR resistance, very good dimensional stability, physiological inertia (suitable for contact with food).

In all plastics at this stage, PE plate wear resistance is better, even many metal materials such as carbon steel, stainless steel plate, brass and other standard wear is not as good as PE plate, with the rise of high pressure polyethylene relative molecular mass, this kind of raw materials are more resistant to wear. Polyethylene resin is a polymer material composed of a number of ethylene polymerization reaction, due to stable chemical properties, heating side group elimination, the main chain is generally open or only disconnected from the weak key, the performance of little impact. Non degradable plastics.

When managing temperature and humidity in a warehouse, you need to adjust the temperature and humidity of the warehouse according to the natural climate and the changing rules of temperature and humidity in the warehouse, and according to the natural properties and characteristics of commodities, and rationally use sealing, ventilation, and hygroscopic methods to achieve safe storage. In order to change the difficulties caused by the poor fluidity of raw materials and the increase of gas phase, some lubricants should be selected when selecting raw materials. The choice of lubricants mainly includes stearic acid and salts. The pPE sheet material produced in this way is uniform without bubbles.

When the installation is completed the user profile and peel PE protective film from the material surface, viscose with no protective film, PE protective film performance but residue on the material products, it is the user is not willing to see, lead to protective film products in the peel, the tension is greater than the inner force, and residue on the profile. When the machine is shut down, the hard polyvinyl chloride material in the cylinder should be discharged first, and the cylinder should be cleaned immediately with polymer polyethylene PE board, PE board or universal ABS resin, then the machine can be shut down.